Kenwood Marine Radio KCA RC50MR User Manual

KCA-RC50MR

Marine Remote Control

Installation Instructions

Mounting The Remote Control:

1. Select a mounting location that is flat and 1/2” thick or less.

2. Using the supplied rubber gasket as a template, drill the mounting holes and a hole for the wiring

at the desired locations.

3. Mount the remote control according to the diagram in FIG. 1 using supplied hardware.

4. Connect the electrical wiring for power, illumination, and ground as shown in FIG. 1.

Connect supplied data line to remote, route to the radio and connect to the connector on the

rear of the radio as shown in FIG. 2.

2 AMP FUSE

RED

+ 12V switched/ignition

YELLOW Illumination (connect to instrument lighting)

BLACK:

BLUE

ground

Data line (connect to radio)

NUT

LOCK WASHER

WASHER

MOUNTING SURFACE

GASKET

REMOTE

FIG. 1

Data Line Connection

Point:

Note, The rear view of radio and location

of connection point will vary dependent

on radio model.

FIG. 2